Deployment Guide

416 Fabric OS Command Reference
53-1003131-01
flow
2
DESCRIPTION Displays the flow definitions and frame statistics. When used without operand, the --show command
displays the list of all flows configured in Flow Vision.
The show on demand feature allows you to display the statistics of the features without creating a flow.
To display the statistics of the features without creating a flow, you must specify the operands without a
flow name and provide a flow definition. The flow will run for a time interval of 6 seconds and the data will
be displayed for the specified features.
OPERANDS The --show command has the following operands:
flow_name
Displays the parameters and flow statistics for the specified flow. Specify "all" to
display all flows.
-feature feature_list
Displays the statistics for the specified features. Specify "all" to display statistics of
all features.
port_options
Specifies the ingress or egress port options.
-ingrport port
Specifies the ingress port. The port can be in either [slot/]port or D,I (Domain,
Index) format depending on the port mode configured using the -portIdMode
operand.
-egrport port
Specifies the egress port. The port can be in either [slot/]port or D,I format
depending on the port mode configured using the -portIdMode operand.
-mirrorport port
Specifies the port from which mirrored frames exits. The port can be in either
[slot/]port or D,I format depending on the port mode configured using the
-portIdMode operand.
frame_options
Specifies the options that represent the content of the FC frame or attributes of the
frame.
-srcdev device_id
Specifies the 3-byte source ID of the originator device. The device_id can be in
PID or PWWN format depending on the device ID mode configured using the
-deviceIdMode operand. The PID format is 0xDDAAPP, where DD is the Domain
ID, AA is the Area ID and PP is the AL_PA ID. The PWWN format is
"XX:XX:XX:XX:XX:XX:XX:XX". Specify "*" to enumerate all originator devices.
-dstdev device_id
Specifies the 3-byte destination ID of the destination device. The device_id can be
in PID or PWWN format depending on the device ID mode configured using the
-deviceIdMode operand. The PID format is 0xDDAAPP, where DD is the Domain
ID, AA is the Area ID and PP is the AL_PA ID. The PWWN format is
"XX:XX:XX:XX:XX:XX:XX:XX". Specify "*" to enumerate all destination devices.
-lun LUN_id
Specifies the LUN identification in decimal or hexadecimal (2-byte value) format.
The valid range for LUN_id is from 0 through 65535 (0x0000 to 0xFFFF). The
LUN ID includes the addressing mode. If the most significant byte (MSB) is not
specified, 0x00 is used. This operand is not supported by the Flow Generator
feature.