Deployment Guide

476 Fabric OS Command Reference

53-1003131-01

haSyncStop

Disables High Availability state synchronization.

SYNOPSIS hasyncstop

DESCRIPTION Use this command to temporarily disable High Availability (HA) synchronization.

After issuing haSyncStop, the switch does not go back to sync start unless you perform one of the

following actions: reboot the active CP, reboot the standby CP, insert a new standby CP (blade), or issue

the haSyncStart command The time it takes for the HA sync to complete depends on the system

configuration. The HA sync timeout is set to 10 minutes.

NOTES Disabling HA synchronization may cause failover to be disruptive.

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in

place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for

details.

OPERANDS None

EXAMPLES To disable the HA state synchronizing process:

switch:admin> hasyncstop

SEE ALSO haFailover, haShow, haSyncStart