Developers Guide

Fabric OS Message Reference 901
53-1003140-01
SULB-1026
5
Recommended
Action
Wait for the blade to reboot.
SULB-1026
Message Firmware commit operation started on the blade in slot <Slot number>.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that the firmwareCommit command has started on the specified blade. The operation may be
a normal part of firmware download, or it may have started to repair the secondary partition of the blade if
the secondary partition is corrupted.
Recommended
Action
Wait for the firmware commit operation to complete.
SULB-1030
Message The switch has rebooted during relocating the internal firmware image.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that there may be an error caused by an unexpected disruption of the firmwareDownload
command; for example, by powering the switch off and on in the middle of a firmware download. The
error may also be caused by persistent storage hardware failure or by a software error.
Recommended
Action
The firmwareDownload command will continue after the switch has rebooted. Run the
firmwareDownloadStatus command to monitor progress. If the problem persists, contact your switch
service provider.
SULB-1031
Message The switch is relocating an internal firmware image.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that the switch has rebooted with the new firmware and is relocating the application processor
(AP) firmware.