Developers Guide

Fabric OS Message Reference 973
53-1003140-01
ZONE-1046
5
Recommended
Action
No action is required.
ZONE-1046
Message The Default Zone access mode is already set to All Access.
Message Type LOG
Severity INFO
Probable Cause Indicates that the Default Zone access mode is already set to All Access.
Recommended
Action
No action is required.
ZONE-1048
Message ZONE ACA is rejected on the standby.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the standby zoning component did not receive a syncdump command from the primary
side.
Recommended
Action
Synchronize the standby control processor (CP) using the haSyncStart command.
ZONE-1049
Message ZONE AD-DefZone conflict detected while system initialization.
Message Type LOG
Severity ERROR
Probable Cause Indicates that there is an Admin Domain (AD) Default Zone conflict.
Recommended
Action
Verify that the default zoning mode for AD0 is set to No Access using the defzone --show command. If
the default zoning mode is not set to No Access, execute the defzone --noaccess command and then
execute the cfgsave command to commit the default zone mode change.