Messages Reference Guide

152 Fabric OS Message Reference
53-1002749-01
AUTH-1029
5
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1029
Message Failed to get <data type> for <message phase> message: port <port number>, retval
<error code>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the authentication process failed to get a particular authentication value at a certain phase.
Usually this problem is transient. The authentication may fail.
The Data type is the payload or structure that failed to get memory.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1030
Message Invalid message code for <message phase> message: port <port number>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the receiving payload does not have a valid message code for a particular authentication
phase. Usually this problem is transient. The authentication may fail.
Recommended
Action
Reinitialize authentication using the portDisable and portEnable commands or the switchDisable and
switchEnable commands.
If the message persists, execute the supportFtp command (as needed) to set up automatic FTP
transfers; then execute the supportSave command and contact your switch service provider.
AUTH-1031
Message Failed to retrieve secret value: port <port number>.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the secret value was not set properly for the authenticated entity.