Messages Reference Guide

714 Fabric OS Message Reference
53-1002749-01
SEC-1102
5
SEC-1102
Message Fail to download <security data>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the switch failed to download a certificate, security database, or policies. This can happen
when the switch does not get enough resources to complete the operation, the fabric has not stabilized,
or the policy database is an invalid format.
Recommended
Action
Wait for the fabric to become stable and then retry the operation. If the policy database is in an illegal
format (with configDownload command), correct the format and retry the operation.
SEC-1104
Message Fail to get primary <Certificate or public key>.
Message Type LOG
Severity ERROR
Probable Cause Indicates the switch failed to get either the primary certificate or a primary public key.
Recommended
Action
Verify the primary switch has a valid certificate installed and retry the operation. If a valid certificate is not
installed, install a certificate by following the procedure specified in the Fabric OS Administrator's Guide.
SEC-1105
Message Fail to disable secure mode on all switches.
Message Type LOG
Severity ERROR
Probable Cause Indicates the switch failed to disable security in the fabric. This could happen if the switch cannot get the
required resources to complete the command, and sending to a remote domain fails or the remote
domain returns an error.
Recommended
Action
Run the secFabricShow to verify that all switches in the fabric are in the ready state. Retry the
command when all switches are ready.