Deployment Guide

• DP1 GigePort
• DP1 Source IP
• DP1 Destination IP
• DP1 VLAN ID
• DP1 MTU Size
• Compression Mode
• Data L2COS Value
• DSCP Data
• IKE Policy Number
• IPsec Policy Enabled
• Keep Alive Timeout
• MaximumCommunicationRate (Mbps)
• MinimumCommunicationRate (Mbps)
• MaxRetransmitRate
• MinRetransmitRate
• Metric
• Pre-Shared key
• QOS Mapping
• Selective Ack
Ports Explorer tree
The Ports Explorer tree displays on the left side of the window. Items in the tree are displayed as
follows:
• Switches--Switch ID, with switch name in parentheses; for example, 3(MapsSW_202)
• Blades--Slot number of the blade, with blade ID in parentheses; for example, Slot 7(24)
• Ports--Port number; for example, Port 2
• 10G SFP ports-- A yellow triangle displays to visually distinguish the 10 Gbps SFP+ ports.
Actions
The Actions list contains options for all the tasks you can perform on the selected ports. If you select
more than one port, options are available for only the tasks that you can perform on all of the selected
ports. Options are unavailable if they are not applicable to the selected ports.
Port information displays in either a table of ports or information about a specific port, depending on
your selection. If you select a slot or switch, the system displays a table of all the ports for the slot or
switch. If you select a port, the system displays detailed information about the port.
Subtabs
You can view either Basic Mode or Advanced Mode, and view the subtabs that contain additional
information about the port. The available subtabs depend on the type of port selected.
To view basic mode, select View > Basic. When viewing detailed information about a port, Basic
Mode provides these subtabs:
• General --Under this tab, the Actions list provides the following options:
‐ Edit
‐ Rename
Ports Explorer tree
Web Tools Administrator's Guide 97
53-1003169-01