Command Reference Guide

Fabric OS Command Reference 469
53-1002746-01
ipAddrShow
2
ipAddrShow
Displays IP address information for a switch or control processor (CP).
SYNOPSIS ipaddrshow
ipaddrshow [-cp cp_number] | -chassis
ipaddrshow -slot slot [-eth0 | -eth1 | -gate
DESCRIPTION Use this command to display the IP addresses configured in the system.
The -cp option displays the IP address for a specified CP on modular platforms, or use the command
without arguments to display the IP address on a standalone switch, or the IP addresses for both CPs on
a chassis.
On a standalone switch, the command displays the following information:
• Ethernet IP Address
• Ethernet Subnet mask
• The Gateway IP Address
• Dynamic Host Control Protocol (DHCP): on or Off
• IPv6 Autoconfiguration Enabled: Yes or No
• Local IPv6 Addresses
• IPv6 Gateway address
• DHCPv6: on or off
On modular platforms, the command displays the following information:
For the chassis:
• Ethernet IP Address
• Ethernet Subnet mask
For each CP:
• Ethernet IP Address
• Ethernet Subnet mask
• Host Name
• Gateway IP Address
If the IPFC network interface is configured for logical switches:
• IPFC address for Virtual Fabric ID
For each CP:
- Backplane IP address
- IPv6 Autoconfiguration Enabled: Yes or No. If enabled, the command displays:
 All local IPv6 Addresses
 Gateway IP addresses for both CPs
Local IPv6 addresses display the following identifiers:
• IP Address type:
- static - A statically configured IPv6 address.
- stateless - Acquired through stateless autoconfiguration.
• IP Address state: