Release Notes

Fabric OS v7.0.2 Release Notes v1.0 Page 24 of 99
o Look for the Tech Note on Access Gateway Device-Based Mapping in VMware ESX Server.
Brocade HBA/Adapter Compatibility
• Brocade HBA/Adapter should be using driver version 2.3.0.2 or later when attached to 16G ports on
Brocade switches.
D-Port
• D-port tests must be run with FEC disabled. Sometimes, a D-Port test may get stuck in “IN
PROGRESS” state, when FEC is enabled for a port. The D-Port stuck in “IN PROGRESS” state can be
recovered by toggling the port (port disable/enable).
• FOS v7.0.0a and later support the execution of D-Port tests concurrently on up to eight ports on the
switch.
• D-Port tests may only be executed on ports configured for “portcfglongdistance port# L0” or normal
port distance mode. Executing D-Port tests on long distance ports may cause tests to fail due to time
out exceeded.
• Support of D-Port is extended to R_RDY flow control mode. The R_RDY mode is useful for active
DWDM links that do not work in VC_RDY or EXT_VC_RDY flow control modes.
• A new sub-option “-dwdm” is added to “portcfgdport --enable” CLI to configure D-Port over active
activeactive
active
DWDM links. The “-dwdm” option will not execute the optical loopback test while performing D-Port
tests as the active
activeactive
active DWDM links do not provide necessary support to run optical loopback tests.
Encryption Behavior for the Brocade Encryption Switch (BES) and FS8-18
• SafeNet’s KeySecure hosting NetApp’s LKM (SSKM) is supported for data encryption operations with
FOS v7.0.1 or later.
• Use of SSKM with the Brocade encryption solution is only supported for SSKM operating in
PVM mode. Please see SSKM documentation for operating in PVM mode for details.
Operation in HVM mode is not supported.
• It is recommended to use Tight VNC connection to access the management console for SSKM
and LKM key vaults instead of remote desktop. If remote desktop is used, customer may
encounter the following errors related to smart card reader:
 Error communicating with smart card reader.
 Card reader already in use by default key.
 Unable to complete TEP/TAP process as window for selecting card and entering
password does not appear.
• Please refer to SafeNet Keysecure install documentation for setting up and initially
configuring the SSKM key vaults. There are some changes between setting up the SSKMs and
the LKMs. Please refer SafeNet or NetApp documentation for any LKM to SSKM migration
procedures. This migration is not tested/supported with FOS v7.0.1 or later.
• The following is tested and supported with FOS v7.0.1 or later.
 Platform Serial Number: 27CJNQ1
 Platform FW Version: SSKM-1.0-03
 Platform Firmware Build ID: 0.5_secure
 DB version: 166
 SEP FW ID: SEPLuna TDB
 SEP HW ID: Luna K6 TBD
 SEP SW ID: 6.2.0 TBD
 System Card FW ID: 200.5
 Management console version: 1.0 build 18.
• For crypto tape operations, please ensure to use Emulex FC HBA firmware/drivers
2.82A4/7.2.50.007 or higher. Use of lower level firmware/drivers may result in hosts not being able to
access their tape LUNs through a crypto target container.