Administrator Guide

40 Flow Vision Administrator’s Guide
53-1002999-01
Flow Generator references
3
Flow Generator references
The following sections provide additional information about Flow Generator.
Commands related to Flow Generator
The following commands affect or are affected by Flow Generator.
portcfgshow
Entering portcfgshow for a specified port shows the configuration of the SIM-Port. (Highlighted in
red for illustration.)
switch:admin> portcfgshow 8/0
Area Number: 96
Octet Speed Combo: 1(16G|8G|4G|2G)
Speed Level: AUTO(SW)
AL_PA Offset 13: OFF
. . . . .
Mirror Port OFF
SIM Port ON
Credit Recovery ON
F_Port Buffers 48
. . . . .
Compression: OFF
Encryption: OFF
FEC: ON
portperfshow
When you run the portperfshow command, an asterisk (*) represents traffic running on either an
ingress port or an egress port from a Flow Generator flow. For the portperfshow command, the
Transmit Throughput value represents the egress port, and the Receive Throughput value
represents the ingress port.
portstatsclear
Entering portstatsclear for a port clears the Flow Generator frame count for all flows sharing this
port. This is equivalent to the flow --reset command. Refer to “Resetting Flow Generator flow
statistics” on page 37 for details.
portstatsshow
When you run the portstatsshow command, the Transmit Word Count value represents the egress
port, and the Receive Word Count value represents the ingress port. The frame size used for
portstatsshow is 2048 bytes, regardless of what value has been set for the flow.
slotstatsclear
Entering slotstatsclear for a slot clears the Flow Generator frame count for all flows sharing the
ports on that slot.