MIB Reference Guide

330 Fabric OS MIB Reference
53-1002750-01
Q-Bridge MIB
18
dot1qStaticUnicastStatus
1.3.6.1.2.1.17.7.1.3.1.1.4
Read-write This object indicates the status of this entry.
Values:
• other (1) - This entry is currently in use, but the conditions under
which it will remain so differ from the following values.
• invalid (2) - Writing this value to the object removes the
corresponding entry.
• permanent (3) - This entry is currently in use and will remain so
after the next reset of the bridge.
• deleteOnReset (4) - This entry is currently in use and will remain
so until the next reset of the bridge.
• deleteOnTimeout (5) - This entry is currently in use and will remain
so until it is aged out.
dot1qStaticMulticastTable
1.3.6.1.2.1.17.7.1.3.2
Not
accessible
A table containing filtering information for multicast and broadcast MAC
addresses for each VLAN, configured into the device by (local or
network) management specifying the set of ports to which frames
received from specific ports and containing specific multicast and
broadcast destination addresses are allowed to be forwarded.
A value of zero in this table (as the port number from which frames with
a specific destination address are received) is used to specify all ports
for which there is no specific entry in this table for that particular
destination address.
Entries are valid for multicast and broadcast addresses only.
dot1qStaticMulticastEntry
1.3.6.1.2.1.17.7.1.3.2.1
Not
accessible
Filtering information configured into the device by (local or network)
management specifying the set of ports to which frames received from
this specific port for this VLAN and containing this multicast or
broadcast destination address are allowed to be forwarded.
dot1qStaticMulticastAddre
ss
1.3.6.1.2.1.17.7.1.3.2.1.1
Not
accessible
The destination MAC address in a frame to which this entry's filtering
information applies. This object must take the value of a multicast or
broadcast address.
dot1qStaticMulticastReceiv
ePort
1.3.6.1.2.1.17.7.1.3.2.1.2
Not
accessible
This object represents either the value zero or the port number of the
port from which a frame must be received in order for this entry's
filtering information to apply.
A value of zero indicates that this entry applies on all ports of the
device for which there is no other applicable entry.
dot1qStaticMulticastStatic
EgressPorts
1.3.6.1.2.1.17.7.1.3.2.1.3
Read-write The set of port s to which frames received from a specific port and
destined for a specific multicast or broadcast MAC address must be
forwarded, regardless of any dynamic information, for example, from
GMRP.
TABLE 128
Object and OID Access Description