Reference Guide

Fabric OS Command Reference 713

53-1002921-02

portCfgDefault

Resets the port configuration to factory default value.

SYNOPSIS portcfgdefault [slot/][ge]port

DESCRIPTION Use this command to reset all configuration values on a specified port to their factory defaults. This

command persistently disables ports capable of routing, which is the factory default value. Use the

portCfgShow command to display the port configuration.

This command does not change the state of a port. To change the state of an E_Port, use either

switchDisable/switchEnable or portDisable/portEnable.

NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in

place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for

details.

OPERANDS This command has the following operands:

slot

For bladed systems only, specifies the slot number of the port to be reset, followed

by a slash (/).

port

Specifies the number of the port to be reset, relative to its slot for bladed systems.

Use switchShow to list of valid ports.

EXAMPLES To reset a port to factory defaults:

switch:admin> portcfgdefault 1/3

To reset a GbE port to factory defaults:

switch:admin> portcfgdefault 8/ge1

SEE ALSO portCfgEport, portCfgGport, portCfgLongDistance, portCfgLport, portCfgPersistentDisable,

portCfgPersistentEnable, portCfgShow, portCfgSpeed, portCfgTrunkPort