Reference Guide

918 Fabric OS Command Reference
53-1002921-02
portTestShow
2
portTestShow
Displays information from portTest.
SYNOPSIS porttestshow [-ports itemlist]
DESCRIPTION Use this command to display a snapshot of information from portTest. The command output displays
statistical data about past test runs and values for parameters that were set when the test was run. Refer
to the portTest help page for more information on the displayed parameters. The output includes the
following information:
Port number
Displays test status for the port. Values are PASS or FAIL.
PortType
Type of port tested.
PortState
Current State of portTest. Values are NO TEST, TESTING, or TEST DONE.
PortTypeToTest
Groups of ports tested. Values are ALL_PORTS, ALL_E_PORTS,
ALL_L_PORTS, ALL_F_PORTS, ALL_LB_PORTS, or SINGLE_PORT.
Pattern
The pattern of the test packets payload.
Seed
The seed value used with the selected pattern. The default seed value is 0xaa.
UserDelay
The delay between frames sent by portTest in milliseconds. The default value is
10 milliseconds (ms).
TotalIteration
Total number of test iterations.
CurrentIteration
Current test iteration.
TotalFail
Total number of failed tests.
ConsecutiveFail
Number of consecutive failed tests.
StartTime
portTest start time.
StopTime
portTest end time.
Timeout
Number of timed out tests.
ErrorCode
Error code, if any.