Release Notes

Open Defects in Fabric OS v7.2.0
Fabric OS v7.2.0a Release Notes v1.0 Page 52 of 93
Defect ID:
DEFECT000465422
Technical Severity:
Medium
Summary:
D-Port Testing Fails and the reasons for failure is not received as part of CAL in automatic mode
Symptom:
D-Port Testing fails when setting the Link Traffic Test Params for F to HBA links without any reason
in automatic mode.
Feature:
Mgmt Embedded - CAL
Function:
Other
Reported In Release:
FOS7.2.0
Probability:
Low
Defect ID:
DEFECT000465611
Technical Severity:
Medium
Summary:
All the four ICL ports in a QSFP should automatically get disabled and enabled during EX port
configuration.
Symptom:
Inconsistent behavior as Webtools supports automatic disabling enabling during Ex port configuration.
Workaround:
Perform Manual or Auto refresh to get the status updated
Feature:
WebMgmt
Function:
Ports Admin
Reported In Release:
FOS7.2.0
Probability:
Low
Defect ID:
DEFECT000465776
Technical Severity:
Medium
Summary:
FX8-24 blade goes in faulty(51) state on rebooting both CPs of DCX+ simultaneously
Symptom:
FX8-24 may fault with reason code 51.
Workaround:
Disable POST and reboot both CPs.
Feature:
Striker/Spike Platform Services
Function:
Other
Reported In Release:
FOS7.2.0
Probability:
Medium
Defect ID:
DEFECT000465802
Technical Severity:
Medium
Summary:
Webtools does not allow the configuration of the "Signal Loss" area for the Port, E-port, F/L Optical
Port classes.
Symptom:
Webtools does not allow the configuration of the
"Signal Loss" area for the Port, E-port, F/L Optical Port classes.
Feature:
FOS Software
Function:
Web Management
Service Request ID:
1190629
Reported In Release:
FOS7.1.1
Probability:
Medium
Defect ID:
DEFECT000466078
Technical Severity:
Medium
Summary:
Webtool shows a fabric watch license not installed error message while MAPs is enabled
Symptom:
When MAPs is enabled from CLI, selecting Webtools -->Configure-->Fabric Watch opens the Fabric
Watch page with an error message "Fabric Watch is not licensed".
Feature:
WebMgmt
Function:
Fabric Watch
Reported In Release:
FOS7.2.0
Probability:
Medium
Defect ID:
DEFECT000466678
Technical Severity:
Medium
Summary:
MAPS commands inconsistent behavior during the intermediate state where active has v7.2.0 and
standby has v7.1.0 running when doing a single CP firmware downgrade
Symptom:
During single CP firmware downgrade from v7.2.0 to v7.10, when the firmware on standby CP is
downgraded, rebooted to 7.1 and before it is brought up as active CP, MAPS CLI commands behave
inconsistently in this time window. some commands work as expected and others fail with error saying
MAPS is disabled.
Feature:
Advanced Monitoring Services
Function:
Other
Reported In Release:
FOS7.2.0
Probability:
Low