Deployment Guide

ManualsBrandsDell ManualsserversDell Brocade 6520

In the above figure, the MIB browser populated the left side of the window with a MIB tree that you

can navigate.

4. Open Web Tools and select Tasks > Manage > Switch Admin.

5. Click Show Advanced Mode.

6. On the SNMP tab, enter the IP address of the trap receiver and the severity level, and click Apply.

NOTE

The severity level must be Informational (4) in order to forward threshold alerts.

7. Start a Telnet session, and enter the snmpConfig --set mibcapability command at the prompt to

set the SNMP MIB capability.

switch:admin> snmpConfig --set mibcapability

The SNMP Mib/Trap Capability has been set to support

FE-MIB

SW-MIB

FA-MIB

SW-TRAP

FA-TRAP

FA-MIB (yes, y, no, n): [yes]

FICON-MIB (yes, y, no, n): [no]

HA-MIB (yes, y, no, n): [no]

SW-TRAP (yes, y, no, n): [yes] yes

swFCPortScn (yes, y, no, n): [no]

swEventTrap (yes, y, no, n): [no]

swFabricWatchTrap (yes, y, no, n): [no] yes

swTrackChangesTrap (yes, y, no, n): [no]

FA-TRAP (yes, y, no, n): [yes]

connUnitStatusChange (yes, y, no, n): [no]

connUnitEventTrap (yes, y, no, n): [no]

connUnitSensorStatusChange (yes, y, no, n): [no]

connUnitPortStatusChange (yes, y, no, n): [no]

SW-EXTTRAP (yes, y, no, n): [no]

8. Enter the snmpConfig --set snmpv1 or --set snmpv3 (depending on your configuration) command

to configure the SNMP management host IP address.

switch:admin> snmpConfig --set snmpv1

Customizing MIB-II system variables ...

At each prompt, do one of the following:

o <Return> to accept current value,

o enter the appropriate new value,

o <Control-D> to skip the rest of configuration, or

o <Control-C> to cancel any change.

To correct any input mistake:

<Backspace> erases the previous character,

<Control-U> erases the whole line,

sysDescr: [Fibre Channel Switch.]

sysLocation: [End User Premise.]

sysContact: [Field Support.]

authTrapsEnabled (true, t, false, f): [false]

SNMP community and trap recipient configuration:

Community (rw): [Secret C0de]