Administrator Guide

xii Flow Vision Administrator’s Guide
53-1002999-01
The serial number label is located as follows:
• Brocade 300, 5100, 5300, 6505, M6505, 6520, 6547, 7800, VA-40FC, and Brocade
Encryption Switch—On the switch ID pull-out tab located inside the chassis on the port side on
the left
• Brocade 5410, 5424, 5430, 5431, 5450, 5460, 5470, 5480—Serial number label attached to
the module
• Brocade 6510—On the pull-out tab on the front of the switch
• Brocade DCX and DCX 8510-8—On the bottom right on the port side of the chassis
• Brocade DCX-4S and DCX 8510-4—On the bottom right on the port side of the chassis, directly
above the cable management comb
3. World Wide Name (WWN)
Use the wwn command to display the switch WWN.
If you cannot use the wwn command because the switch is inoperable, you can get the WWN
from the same place as the serial number, except for the Brocade DCX Backbone family.
For the Brocade DCX Backbone family, access the numbers on the WWN cards by removing the
Brocade logo plate at the top of the nonport side of the chassis.
For the Brocade 5424 embedded switch, provide the license ID. Use the licenseIdShow
command to display the WWN.
Document feedback
Quality is our first concern at Brocade and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
[e-mail]
Provide the title and version number of the document and as much detail as possible about your
comment, including the topic heading and page number and your suggestions for improvement.