Deployment Guide

Default FCIP monitoring thresholds for Brocade 7840 devices (Continued)TABLE 24
Monitoring statistic Units
MAPS thresholds and actions per
policy
ActionsAggressive Moderate Conservative
Circuit: Packet loss
percentage
(CIR_PKTLOSS)
Percentage per
minute
0.01 0.05 0.1 RASLOG, SNMP,
EMAIL
Circuit: Round-trip
times (RTT)
Total delay in
milliseconds
250 250 250 RASLOG, SNMP,
EMAIL
Circuit: Jitter (JITTER) Percentage of delay
This is calculated
using difference of
two successive
minutes, with the
total delay in
milliseconds
averaged per minute
for each minute. A
value of less than 5
ms in the converted
percentage is
ignored.
5 15 20 RASLOG, SNMP,
EMAIL
FRU state thresholds
For all FRU monitoring statistics (PS, Fan, SFP, SFP Blade, WWN), the default MAPS thresholds that
are part of blade and WWN rules for Brocade DCX and Brocade DCX+ systems, are the same for all
policies (In, Out, Off, Faulty), and the actions are the same (RASLOG, SNMP, EMAIL). All threshold
conditions are absolute, and actions are triggered when the statistic value either does or does not
match the value (depending on how the rule is written).
Port Health monitoring thresholds
All Port Health monitoring thresholds used by MAPS are triggered when they exceed the listed value.
For thresholds that have both an upper value and a lower value, the threshold is triggered when it
exceeds the upper value or drops below the lower value. All thresholds other than RXP, TXP, and
Utilization percentage are measured per minute. The RXP, TXP, and Utilization percentage thresholds
are measured per hour.
D_Port default Port Health monitoring thresholds
The following tables lists the default Port Health monitoring thresholds for D_Ports, broken out by
standard policy.
FRU state thresholds
100 Monitoring and Alerting Policy Suite Administrator's Guide
53-1003147-01