Command Reference Guide

Fabric OS Command Reference 293

53-1002746-01

fcipLedTest

Exercises the GbE port LEDS on the Brocade 7800 and FX8-24.

SYNOPSIS fcipledtest [slot | all]

DESCRIPTION Use this command to exercise the GbE port LEDs on the Brocade 7800 and FX8-24. This test cycles

through the port LEDs by lighting GREEN and then flashing GREEN on all ports for 3 seconds. As the

test continues the ports turn AMBER and then flashing AMBER for 3 seconds. The LEDs turn off when

the test has finished.

You must disable the switch before running this command.

NOTES The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in

place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for

details.

OPERANDS This command has the following operands:

slot

Tests all GbE ports in the specified slot. This operand is optional; if omitted, all

GbE ports are tested. This operand is valid only on chassis-based platforms.

all

Tests all ports on the switch.

EXAMPLES To test the LEDs on slot 4 of Brocade DCX with an FX8-24 blade.

switch:admin> fcipledtest 4

PASSED.

SEE ALSO ceePortLedTest, portLedTest, switchDisable, switchEnable