Developers Guide

896 Fabric OS Message Reference
53-1003140-01
SULB-1009
5
• 0x15 - "Failed to download RPM package." If this error occurs immediately after firmware
download is started, the firmware on the switch may be two releases older than the requested
firmware. The firmware download operation supports firmware upgrades within two feature
releases (a feature release is indicated by a major number and a minor number; for example,
X.Y). In this case, you will need to upgrade to an intermediate version before downloading the
desired version. If this error occurs in the middle of a firmware download, the firmware in the
file server may be corrupted or there may be a temporary network issue. In this case, retry the
firmwareDownload command. If the problem persists, contact your system administrator.
• 0x18 - "Error in getting lock device for firmware download". This error can be due to another
firmware download is already in progress. Run the firmwareDownloadStatus command to verify
that this is the case. Wait for the current session to finish before proceeding.
• 0x23 - "Firmware download timed out." This error may occur because the
firmwareDownloadStatus command has not completed within the predefined timeout period. It
is most often caused by network issues. If the problem persists, contact your system
administrator.
• 0x24 - "Out of disk space." This error may occur because some core dump files have not been
removed from the filesystem and are using up disk space. Remove these core dump files by
using the supportSave command before proceeding.
• 0x29 - "The pre-install script failed." This error may be caused by an unsupported blade type.
Remove or power off the unsupported blades before proceeding.
• 0x2e - "Invalid RPM package." This error may be caused by an inconsistent firmware image
loaded on the file server. It may also be caused by temporary networking issues. Reload the
firmware packages on the file server and then retry the firmwareDownload command. If the
problem persists, contact your system administrator.
The following table lists the firmwareDownload state names and code values. They indicate where
in the firmwareDownload process the error occurred.
TABLE 9 Upgrade state and code value
Upgrade state Code
SUS_PEER_CHECK_SANITY 0x21
SUS_PEER_FWDL_BEGIN 0x22
SUS_SBY_FWDL_BEGIN 0x23
SUS_PEER_REBOOT 0x24
SUS_SBY_REBOOT 0x25
SUS_SBY_FABOS_OK 0x26
SUS_PEER_FS_CHECK 0x27
SUS_SELF_FAILOVER 0x28
SUS_SBY_FWDL1_BEGIN 0x29
SUS_SELF_FWDL_BEGIN 0x2a
SUS_SELF_COMMIT 0x2b
SUS_SBY_FWC_BEGIN 0x2c
SUS_SBY_COMMIT 0x2d
SUS_SBY_FS_CHECK 0x2e
SUS_ACT_FWC_BEGIN 0x2f