Messages Reference Guide

672 Fabric OS Message Reference
53-1002749-01
RCS-1001
5
RCS Messages
RCS-1001
Message RCS has been disabled. Some switches in the fabric do not support this feature.
Message Type LOG
Severity INFO
Probable Cause Indicates that the reliable commit service (RCS) feature has been disabled on the local switch because
not all switches in the fabric support RCS or the switch is in non-native mode.
Recommended
Action
Run the rcsInfoShow command to view RCS capability on the fabric. RCS is supported in Fabric OS
v2.6, v3.1 and later, and v4.1 and later.
Run the firmwareDownload command to upgrade the firmware for any switches that do not support
RCS.
RCS-1002
Message RCS has been enabled.
Message Type LOG
Severity INFO
Probable Cause Indicates that the reliable commit service (RCS) feature has been enabled. RCS must be capable on all
switches in the fabric to be enabled. If all switches are capable, it is automatically enabled.
Recommended
Action
No action is required.
RCS-1003
Message Failed to allocate memory: (<function name>).
Message Type LOG
Severity ERROR
Probable Cause Indicates that the specified reliable commit service (RCS) function has failed to allocate memory.
Recommended
Action
This message is usually transitory. Wait for few minutes and retry the command.
Check memory usage on the switch using the memShow command.
Reboot or power cycle the switch.