Messages Reference Guide

Fabric OS Message Reference 825
53-1002749-01
SULB-1001
5
SULB Messages
SULB-1001
Message Firmwaredownload command has started.
Message Type AUDIT | LOG
Class FIRMWARE
Severity WARNING
Probable Cause Indicates that the firmwareDownload command has been entered. This process should take
approximately 17 minutes. The process is set to time out after 30 minutes.
Recommended
Action
Do not fail over or power down the system during firmware upgrade. Allow the firmwareDownload
command to continue without disruption. No action is required.
Run the firmwareDownloadStatus command for more information.
SULB-1002
Message Firmwaredownload command has completed successfully.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmwareDownload command has completed successfully and switch firmware has
been updated.
Recommended
Action
No action is required. The firmwareDownload command has completed as expected.
Run the firmwareDownloadStatus command for more information. Run the firmwareShow command
to verify the firmware versions.
SULB-1003
Message Firmwarecommit has started.
Message Type AUDIT | LOG
Class FIRMWARE
Severity INFO
Probable Cause Indicates that the firmwareCommit command has been entered.