Messages Reference Guide

830 Fabric OS Message Reference
53-1002749-01
SULB-1009
5
The following table lists additional firmwareDownload error messages and error codes. The error
code provide more details on the reason for firmware download failure.
"Remote CP is restoring its secondary partition." 0x8e
"Firmware download has started." 0x8f
"Firmware commit has started." 0x90
"Firmware download has completed successfully." 0x91
"Firmware commit has completed successfully." 0x92
"Firmware commit has started to restore the secondary partition." 0x93
"Firmware commit failed." 0x94
"The secondary partition has been restored successfully." 0x95
"Firmware is being downloaded to the blade. This step may take up to 10 minutes." 0xa0
"Firmware download timed out." 0xa1
"Reboot occurred during firmware download. Firmware commit will be started to
recover the blade."
0xa2
"Blade rebooted during firmware commit. The operation will be restarted." 0xa3
"Firmware has been downloaded successfully. Blade is rebooting with the new
firmware."
0xa4
"Blade has rebooted successfully." 0xa5
"New firmware failed to boot up. Run the
firmwareDownload command again." 0xa6
"Firmware commit has started on the blade. This may take up to 10 minutes." 0xa7
"The
firmwareRestore command is entered. System will reboot and a firmware
commit operation will start upon bootup."
0xa8
"Switch is relocating the AP image." 0xa9
"The AP image is relocated successfully." 0xaa
"Switch reboots during relocating the AP image. The operation will be restarted." 0xab
"Blade failed to reboot with the original image. The
firmwareRestore command
failed."
0xac
TABLE 8 Error messages and error codes
Error message Error code
"Image is up-to-date. No need to download the same version of firmware." 0xF
"Upgrade is inconsistent." 0x10
"OSRootPartition is inconsistent. For example: swap OSRootPartitions and reboot." 0x11
"Unable to access the required package list file. Check whether the switch is
supported by the requested firmware. Also check the
firmwareDownload help
page for other possible failure reasons."
0x12
"The RPM package database is inconsistent. Contact your switch service provider for
recovery."
0x13
TABLE 7 Status messages and status codes (Continued)
Status message Status code