Messages Reference Guide

836 Fabric OS Message Reference

53-1002749-01

SULB-1023

Message The blade in slot <Slot number> has rebooted during firmwaredownload.

Message Type AUDIT | LOG

Class FIRMWARE

Severity WARNING

Probable Cause Indicates that there may be an error caused by an unexpected disruption of the firmwareDownload

command; for example, powering off and on of the indicated BP blade in the middle of a firmware

download. The error may also be caused by persistent storage hardware failure or by a software error.

Recommended

Action

The firmwareCommit command will be started automatically after the blade boots up to repair the

secondary partition. If at the end of the firmware commit, the blade firmware version is still inconsistent

with the active CP firmware, firmware download will be restarted automatically on the blade. Run the

firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your

switch service provider.

SULB-1024

Message Firmware commit has completed on the blade in slot <Slot number>.

Message Type AUDIT | LOG

Class FIRMWARE

Severity WARNING

Probable Cause Indicates that the firmwareCommit command has completed on the specified blade.

Recommended

Action

Run the firmwareShow command to verify the firmware versions. If the blade firmware is the same as

the active CP firmware, the firmwareDownload command has completed successfully on the blade.

However, if the firmware commit operation has been started to repair the secondary partition, at the end

of the firmware commit, the blade firmware version may still be inconsistent with the active CP firmware.

In this case, firmware download will automatically be restarted on the blade. Run the

firmwareDownloadStatus command to monitor the progress.

SULB-1025

Message The blade in slot <Slot number> will reboot with the new firmware.

Message Type LOG

Severity WARNING

Probable Cause Indicates that new firmware has been downloaded to the specified application processor (AP) blade and

the AP blade will reboot to activate it.