Reference Guide

The following is an example of an empty access list
switch:admin> msconfigure
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 1
MS Access list is empty.
0 Done
1 Display the access list
2 Add member based on its Port/Node WWN
3 Delete member based on its Port/Node WWN
select : (0..3) [1] 0
done ...
Adding a member to the ACL
Use the following procedure to add a member to the ACL:
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the msConfigure command.
The command becomes interactive.
3. At the "select" prompt, enter 2 to add a member based on its port/node WWN.
4. At the "Port/Node WWN" prompt, enter the WWN of the host to be added to the ACL.
5. At the "select" prompt, enter 1 to display the access list so you can verify that the WWN you entered was added to the ACL.
6. After verifying that the WWN was added correctly, enter 0 at the prompt to end the session.
7. At the "Update the FLASH?" prompt, enter y .
8. Press Enter to update the nonvolatile memory and end the session.
Understanding Fibre Channel Services
Brocade Fabric OS Administration Guide, 8.0.1
28 53-1004111-02