Reference Guide

Abandoning zone configuration changes
To abandon zone configuration changes, enter the cfgTransAbort command.
When this command is executed, all changes since the last save operation (performed with the cfgSave , cfgEnable , or cfgDisable
command) are cleared.
Example of assuming that the removal of a member from zone1 was done in error
switch:admin> zoneremove "zone1","3,5"
switch:admin> cfgtransabort
Viewing all zone configuration information
If you do not specify an operand when executing the cfgShow command to view zone configurations, then all zone configuration
information (both defined and effective) displays. If there is an outstanding transaction, then the newly edited zone configuration that has
not yet been saved is displayed. If there are no outstanding transactions, then the committed zone configuration displays.
Use the following procedure to view all zone configuration information.
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the cfgShow command with no operands.
Example
switch:admin> cfgshow
Defined configuration:
cfg: USA1 Blue_zone
cfg: USA_cfg Purple_zone; Blue_zone
zone: Blue_zone
1,1; array1; 1,2; array2
zone: Purple_zone
1,0; loop1
alias: array1 21:00:00:20:37:0c:76:8c; 21:00:00:20:37:0c:71:02
alias: array2 21:00:00:20:37:0c:76:22; 21:00:00:20:37:0c:76:28
alias: loop1 21:00:00:20:37:0c:76:85; 21:00:00:20:37:0c:71:df
Effective configuration:
cfg: USA_cfg
zone: Blue_zone
1,1
21:00:00:20:37:0c:76:8c
21:00:00:20:37:0c:71:02
1,2
21:00:00:20:37:0c:76:22
21:00:00:20:37:0c:76:28
zone: Purple_zone
1,0
21:00:00:20:37:0c:76:85
21:00:00:20:37:0c:71:df
Viewing selected zone configuration information
Use the following procedure to view the selected zone configuration information.
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the cfgShow command and specify a pattern.
cfgshow [--ic][,"pattern"] [, mode]
Administering Advanced Zoning
Brocade Fabric OS Administration Guide, 8.0.1
326 53-1004111-02