Reference Guide

Examples
Example: Displaying information about the TI zone purplezone
switch:admin> zone --show purplezone
Defined TI zone configuration: TI Zone Name: redzone:
Port List: 1,2; 1,3; 3,3; 4,5
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
Example: Displaying information about all TI zones in the defined configuration in ascending order
switch:admin> zone --show -ascending
Defined TI zone configuration: TI Zone Name: bluezone:
Port List: 8,3; 8,5; 9,2; 9,3;
Configured Status: Deactivated / Failover-Disabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name: greenzone:
Port List: 2,2; 3,3; 4,11; 5,3;
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
TI Zone Name: purplezone:
Port List: 1,2; 1,3; 3,3; 4,5;
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated / Failover-Enabled
Example: Displaying members for the zone "ti_red" in ascending order
switch:admin> zone --show -ascending ti_red
Defined TI zone configuration:
TI Zone Name: ti_red
Port List: 3,3; 4,4; 5,5
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated
Example: Displaying members for the zone "TI_zone", regardless of the case
switch:admin> zone --show -ic TI_zone* Defined TI zone configuration:
TI Zone Name: TI_zone
Port List: 7,8
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated
TI Zone Name: ti_zone
Port List: 3,3
Configured Status: Activated / Failover-Enabled
Enabled Status: Deactivated
Enforcing Local TI Filtering
Local TI Filtering prevents or restricts unwanted traffic flow by enforcing local-to-local TI zone rules.
Prior to Fabric OS 7.4.0, if regular zoning of local-to-local flows did not reflect the same connectivity as the TI zoning, there were cases
where the Name Server reported that the connectivity was allowed, but the connectivity was restricted at the routing layers due to TI
zoning rules.
Starting with Fabric OS 7.4.0, the Local TI Filtering feature enforces the TI zone rules on local-to-local flows.
Use the configure command to configure Local TI Filtering. By default, this feature is disabled. Disable the switch before configuring
Local TI Filtering.
Traffic Isolation Zoning
Brocade Fabric OS Administration Guide, 8.0.1
53-1004111-02 369