Reference Guide

cfg: <current effective configuration
>
...
switch:admin> cfgenable <current effective configuration
>
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected. If the update includes changes
to one or more traffic isolation zones, the update may result in
localized disruption to traffic on ports associated with
the traffic isolatoin zone changes
Do you want to enable ’TI_Config’ configuration (yes, y, no, n): [no] y
zone config "name" is in effect
Updating flash ...
switch:admin>
Switch:admin> zone --show
Defined TI zone configuration:
TI Zone Name: TI_Zone_ALL
Port List: 20,3; 20,4; 20,5; 20,6; 30,7; 30,8; 30,9; 30,10
Configured Status: Activated / Failover-Enabled
Enabled Status: Activated / Failover-Enabled
Then enabled status now displays as "Activated".
Setting up TI zones over FCR (sample procedure)
The following example shows how to set up TI zones over FCR to provide a dedicated path shown in Figure 48. In this example, three TI
zones are created: one in each of the edge fabrics and one in the backbone fabric. The combination of these three TI zones creates a
dedicated path for traffic between Host 1 in edge fabric 1 and Targets 1 and 2 in edge fabric 2.
Host 1 has port WWN 10:00:00:00:00:08:00:00
Target 1 has port WWN 10:00:00:00:00:02:00:00
Target 2 has port WWN 10:00:00:00:00:03:00:00
Traffic Isolation Zoning
Brocade Fabric OS Administration Guide, 8.0.1
378 53-1004111-02