Reference Guide

FIGURE 53 Logical representation of TI zones over FC routers in logical fabrics
Troubleshooting TI zone routing problems
Use the following procedure to generate a report of existing and potential problems with TI zones. The report displays an error type.
∙ "ERROR" indicates a problem currently exists in the fabric.
∙ "WARNING" indicates that there is not currently a problem, given the current set of online devices and reachable domains, but
given the activated TI zone configuration, parallel exclusive paths between a shared device and a remote domain have been
detected, which might cause a problem for devices that join the fabric later.
1. Connect to the switch and log in using an account with admin permissions.
2. Enter the zone --showTIerrors command.
zone --showTIerrors
Here is an example report that would be generated for the illegal configuration shown in Figure 41 on page 363.
switch:admin> zone --showTIerrors
My Domain: 3
Error type: ERROR
Affected Remote Domain: 1
Affected Local Port: 8
Affected TI Zones: etiz1, etiz2
Affected Remote Ports: 1, 2, 3, 4
Traffic Isolation Zoning
Brocade Fabric OS Administration Guide, 8.0.1
53-1004111-02 385