Reference Guide

FIGURE 61 Single Access Gateway to switch
The above topology is supported only with static-static D_Port modes.
The following figure illustrates multiple Access Gateways connected to a switch in a cascaded topology. The letters N and F represent,
respectively, an N_Port and an F_Port to be configured as D_Ports.
FIGURE 62 Multiple Access Gateways cascaded to switch
The above topology is supported only with static-static D_Port modes.
NOTE
N_Port-to-F_Port and device (WWN) mappings must be removed from an Access Gateway port before configuring the Access
Gateway port as a D_Port. Refer to Saving port mappings on an Access Gateway on page 424.
The following figure illustrates connectivity between an HBA and an Access Gateway. The letter F represents an F_Port to be configured
as a D_Port.
Diagnostic Port
Brocade Fabric OS Administration Guide, 8.0.1
53-1004111-02 423