Reference Guide

FIGURE 74 Switch in Access Gateway mode with F_Port masterless trunking
NOTE
You do not need to map the host to the master port manually because the Access Gateway will perform a cold failover to the
master port.
Refer to Configuring F_Port trunking for an Access Gateway on page 477 for instructions on configuring F_Port trunking.
Requirements for F_Port trunking on an Access Gateway
In addition to the requirements listed in Requirements for trunk groups on page 469, refer to the Access Gateway Administrator's Guide
for additional requirements that are specific to F_Port trunking on an Access Gateway.
Configuring F_Port trunking for an Access Gateway
Access Gateway trunking configuration is mostly on the edge switch. On the Access Gateway module, you only need to ensure that the
Trunking license is applied and enabled.
Use the following procedure on the edge switch connected to the Access Gateway module to configure F_Port trunking.
1. Connect to the switch and log in using an account assigned to the admin role.
Managing Trunking Connections
Brocade Fabric OS Administration Guide, 8.0.1
53-1004111-02 477