Reference Guide

Info : This feature got enabled on all Management Interfaces of this chassis
Done.
2. To display the configured IP address, run the ipAddrShow command.
switch:admin>ipaddrshow
CHASSIS
Ethernet IP Address: 10.17.46.231
Ethernet Subnetmask: 255.255.240.0
CP0
Ethernet IP Address: 10.17.46.228
Ethernet Subnetmask: 255.255.240.0
Host Name: cp0
Gateway IP Address: 10.17.32.1
CP1
Ethernet IP Address: 10.17.46.229
Ethernet Subnetmask: 255.255.240.0
Host Name: cp1
Gateway IP Address: 10.17.32.1
3. To disable DHCP for IPv4 on Directors, follow these steps.
When you disable DHCP, the previously configured static Ethernet IP address, the subnet mask, and the default gateway
addresses are restored as active configuration.
∙ In interactive mode:
switch:admin>ipaddrset -chassis
DHCP [On]:off
IP address is being changed...
Done
∙ In a single command:
switch:admin>ipaddrset -chassis -ipv4 -add -dhcp off
IP address is being changed...
Done.
Configuring DHCPv6 for IPv6
You can configure the IPv6 address from the DHCPv6 server.
1. Run the ipAddrSet –ipv6 –dhcpv6 command.
2. To display the configured IPv6 address, run the ipAddrShow command.
∙ In case of fixed-port switches, the following output displayed:
switch:admin>ipaddrshow
SWITCH
Ethernet IP Address: 10.17.33.33
Ethernet Subnetmask: 255.255.240.0
Gateway IP Address: 10.17.32.1
DHCP: Off
IPv6 Autoconfiguration Enabled: No
Local IPv6 Addresses:
dhcpv6 2620:100:0:f603::f9ff/64 preferred
link local fe80::205:33ff:fe3a:77f9/64
IPv6 Gateways:
fe80::21b:edff:fe0b:9000
DHCPv6: On
∙ In case of Backbone Directors, the following output is displayed:
switch:admin>ipaddrshow
CHASSIS
Performing Basic Configuration Tasks
Brocade Fabric OS Administration Guide, 8.0.1
53-1004111-02 53