Reference Guide

FIGURE 3 Blade swap with Virtual Fabrics during the swap
4. Port swapping
The swap ports action is an iteration of the portSwap command for each port on the source blade to each corresponding port
on the destination blade.
As shown in the following figure, the blades can be divided into different logical switches as long as they are divided the same
way. If slot 1 and slot 2 ports 0 through 7 are all in the same logical switch, then blade swapping slot 1 to slot 2 will work. The
entire blade does not need to be in the same partition.
Performing Advanced Configuration Tasks
Brocade Fabric OS Administration Guide, 8.0.1
53-1004111-02 93