Reference Guide

FIGURE 4 Blade swap with Virtual Fabrics after the swap
Swapping blades
Use the following procedure to swap blades.
1. Connect to the Backbone and log in using an account with admin permissions.
2. Enter the bladeSwap command.
If no errors are encountered, the blade swap will complete successfully. If errors are encountered, the command is interrupted
and the ports are set back to their original configurations.
3. Once the command completes successfully, move the cables from the source blade to the destination blade.
4. Enter the bladeEnable command on the destination blade to enable all user ports.
Performing Advanced Configuration Tasks
Brocade Fabric OS Administration Guide, 8.0.1
94 53-1004111-02