Setup Guide
Viewing the overall status of the switch
1. Connect to the switch and log in as admin.
2. Enter the mapsdb --show command.
switch:admin> mapsdb --show
1 Dashboard Information:
=======================
DB start time: Thu Feb 4 19:17:13 2016
Active policy: dflt_aggressive_policy
Configured Notifications: RASLOG,EMAIL,FENCE
Fenced Ports : 5/60,5/62
Decommissioned Ports : None
Fenced circuits : None
Quarantined Ports : None
Top PIDs <pid(it-flows)>: 0x69b0c0(8) 0x697b00(4)
2 Switch Health Report:
=======================
Current Switch Policy Status: CRITICAL
Contributing Factors:
---------------------
*BAD_PWR (CRITICAL).
*BAD_FAN (MARGINAL).
3.1 Summary Report:
===================
Category |Today |Last 7 days |
--------------------------------------------------------------------------------
Port Health |Out of operating range |No Errors |
BE Port Health |No Errors |No Errors |
GE Port Health |In operating range |No Errors |
Fru Health |Out of operating range |In operating range |
Security Violations |No Errors |No Errors |
Fabric State Changes |Out of operating range |No Errors |
Switch Resource |In operating range |In operating range |
Traffic Performance |In operating range |In operating range |
FCIP Health |No Errors |No Errors |
Fabric Performance Impact|In operating range |In operating range |
3.2 Rules Affecting Health:
===========================
Category |Repeat|Rule Name |Execution Time |Object |Triggered |
(Rule Count) |Count | | | |Value(Units)|
-------------------------------------------------------------------------------------
Fru Health(2)|2 |defALL_PSPS_ |02/04/16 21:32:16 |Power Supply 3 |FAULTY |
| |STATE_FAULTY | | | |
| | | |Power Supply 4 |FAULTY |
For more information on how the overall switch status is determined, refer to the switchStatusPolicySet command in the
Fabric
OS Command Reference
.
If Flow Vision is enabled the following message appears:
ras225:FID128:admin> switchstatusshow
MAPS is enabled, Fabric Watch is disabled. Please use MAPS for monitoring and execute mapsHelp
command for available MAPS commands.
Displaying switch information
To display the switch information, perform the following task.
1. Connect to the switch and log in as admin.
2. Enter the switchShow command.
Table 14 lists the switch summary information.
Diagnostic Features
Brocade Fabric OS Troubleshooting and Diagnostics Guide
86 53-1004126-01