Setup Guide

FIGURE 5 Port mapping example
The following table describes the port mapping details shown in the example.
TABLE 6 Description of port mapping
Access Gateway Fabric
F_Port N_Port Edge switch F_Port
F_1, F_2 N_1 Switch_A F_A1
F_3, F_4 N_2 Switch_A F_A2
F_5, F_6 N_3 Switch_B F_B1
F_7, F_8 N_4 Switch_B F_B2
Default port mapping
When you enable AG mode on a switch, a default mapping is used for the F_Ports and N_Ports. The following table describes the
default port mapping for all supported hardware platforms.
NOTE
By default, Failover and Failback policies are enabled on all N_Ports.
Configuring Ports in Access Gateway Mode
Brocade Fabric OS Access GatewayAdministration Guide
28 53-1004110-01