Setup Guide

Failback example
In the following figure, the Access Gateway N_1 remains disabled because the corresponding F_A1 port is offline. However, N_2 comes
back online. Refer to Failover example on page 62 for the original failover scenario.
Ports F_1 and F_2 are mapped to N_1 and continue routing to N_3. Ports F_3 and F_4, which were originally mapped to N_2, are
disabled and rerouted to N_2, and then enabled.
FIGURE 12 Failback behavior
Enabling and disabling the Failback policy on an N_Port
Use the following steps to enable or disable the Failback policy on N_Ports.
1. Connect to the switch and log in using an account assigned to the admin role.
2. Enter the ag --failbackshow n_portnumber command to display the failback setting.
switch:admin> ag --failbackshow 13
Failback on N_Port 13 is not supported
3. Use the following commands to enable or disable the Failback policy:
Managing Policies and Features in Access Gateway Mode
Brocade Fabric OS Access GatewayAdministration Guide
53-1004110-01 67