Reference Guide

Brocade Fabric OS Command Reference 1019
53-1004112-02
slotShow
FAULTY
The blade is faulty because an error was detected. A fault code of 53 may also indicate the
possibility of a rolling reboot detection (RRD) on the specified blade. In the case of an RRD,
investigate and correct the cause, then reboot the control processor (CP) to recover the
blade.
UNKNOWN
The blade is inserted but its state cannot be determined.
Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric
OS Commands" and "Command Availability" for details.
In a X6-4 chassis, slot 1 and 2 (Blade ID 175) are occupied by control processor blades and slot 5 and 6 (Blade ID
176) are occupied by core blades. In a X6-8 chassis, slot 1 and 2 (Blade ID 175) are occupied by the control
processor blades and slot 7 and 8 (Blade ID 177) are occupied by core blades..
Operands This command supports the following operands:
-p
In addition to the basic slot status view, displays the following information about power
consumption:
• Total direct current (DC) power consumption for the chassis and individual values for
each blade (in Watts). Usage for other components such the WWN card or fans is
included in the calculation but not listed per component. Note that the data displayed in
the "DC Power Consumption" column and in the summary field "Total DC Power
consumption" indicate the maximum allowed power consumption, not a real-time
value. Real-time power consumption data is displayed for 16G platforms only with the
chassisShow command.
• Total alternating current (AC) power consumption in Watts. This value indicates the
maximum allowed AC power consumption; it is not a real-time value.
• AC efficiency, as a percentage of total and BTU.
• Power efficiency in Watts/port and Watts/Gb.
-m
In addition to the basic slot status view, displays the Brocade model name for each blade.
Examples To display the status of all slots on a Brocade X6-8:
switch:user> slotshow
Slot Blade Type ID Status
---------------------------------
1 CP BLADE 175 ENABLED
2 CP BLADE 175 ENABLED
3 AP BLADE 186 ENABLED
4 AP BLADE 186 ENABLED
5 SW BLADE 178 ENABLED
6 SW BLADE 178 ENABLED
7 CORE BLADE 177 ENABLED
8 CORE BLADE 177 ENABLED
9 AP BLADE 186 ENABLED
10 SW BLADE 178 ENABLED
11 SW BLADE 178 ENABLED
12 AP BLADE 186 ENABLED