Reference Guide

Brocade Fabric OS Command Reference 1027
53-1004112-02
snmpConfig
-enable | -disable [informs]
Enables or disables informs. If informs are enabled, all trap destinations receive inform
requests. If informs are disabled, all trap destinations receive trap requests. When informs
are enabled, the engine ID must be set to correspond to the management engine IP
address. Informs are by default disabled. IPv6 Informs are currently not supported.
-user user_name
Specifies the name of the user that connects to the agent. The user name must be between
2 and 32 characters long. The default user names are defined with the noAuth and noPriv
protocol. The factory default SNMPv3 user names include the following:
User 1: snmpadmin1
User 2: snmpadmin2
User 3: snmpadmin3
User 4: snmpuser1
User 5: snmpuser2
User 6: snmpuser3
-auth_proto auth_protocol
Specifies the authentication protocol as MD5, SHA, or no authentication for each entry. The
following combinations of protocols are supported:
NoAuth/NoPriv
Auth/NoPriv
Auth/Priv
-auth_passwd auth_password
Specifies the authentication password that enables the agent to receive packets from the
host. Passwords are plain text and must be added each time for each configuration replay.
The password must be between 1 and 32 characters long.
-priv_proto priv_protocol
Specifies privacy authentication level setting. The vald values are DES and AES128.
-priv_passwd priv_password
Specifies the privacy password that enables the host to encrypt the contents of the
message that it sends to the agent. Passwords are plain text and must be added each time
for each configuration replay. The privacy password alone cannot be configured. You
configure the privacy password with the authentication password.
-engine_id engine_id
Configures a user-defined engine ID for the SNMP agent.
-notify_type trap | informs
Specifies the type of notification traps that are sent for the host. Traps and informs are
supported. The default notify type is traps.
--set mibcapability
Configures MIBs.