Reference Guide

1028 Brocade Fabric OS Command Reference
53-1004112-02
snmpConfig
-mib_name mib_name
Specifies the name of the MIB to be configured. This operand is required if you want to
configure MIB traps noninteractively. Valid MIB names include the following.
• FE-MIB
• SW-MIB
• FA-MIB
• FICON-MIB
• HA-MIB
• FCIP-MIB
• ISCSI-MIB
• IF-MIB
• MAPS-MIB
• T11-FC-ZONE-SERVER-MIB
-bitmask bit_mask
Specifies the bit mask for the MIB. Refer to the table above for valid values.
-trap_name trap_name
Specifies the name of the trap to be enabled or disable. This operand is optional. Use
snmpconfig --show mibcapability for a listing of valid traps.
accessControl
Selects access-control-related parameters. These parameters include the access host
subnet area and access permission (read-write).
-host ip_address
Specifies the host IP address with or without a subnet mask.
-access [ro | rw
Specifies the read-write (rw) or read-only (ro) access to the host.
systemGroup
Selects configuration parameters related to the system group.
-sysdescr sysdescr
Specifies the system description. The default value is "Fibre Channel Switch".
-syslocation syslocation
Specifies the location of the system (switch). The default value is "End User Premise".
The string must be at least 4 characters in length; the maximum length is 255
characters. If special characters are used in the syslocation, the syslocation must be
enclosed in single quotes.
-syscontact syscontact
Specifies the contact information for this system (switch). The default value is "Field
Support". Refer to the definition of sysDescr, sysLocation and sysContact in the system
group of MIB-II. The string must be at least 4 characters in length; the maximum length
is 255 characters. If special characters are used in the syscontact, the syscontact must
be enclosed in single quotes.