Reference Guide

1060 Brocade Fabric OS Command Reference
53-1004112-02
supportShow
iswitch
FC Router group commands, disabled by default.
asic_db
ASIC DB group commands, disabled by default.
fcip
FCIP group commands, disabled by default.
ag
Access Gateway group commands, disabled by default.
dce_hsl
DCE group commands, enabled by default.
crypto
Encryption group commands, disabled by default.
Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric
OS Commands" and "Command Availability" for details.
This is a diagnostic command and should only be run for diagnostic support.
Output generated by this command may vary by switch configuration and platform. Output may change without
notice.
Operands This command has the following operands:
slot
On bladed systems only, specifies a slot number.
port1-port2
Specifies a port or a range of ports for which to display supportShow information. This
operand is optional; if omitted, the command displays information for all ports. The
following values are supported:
• A single port in port1-port1 format, for example, "5/8-8".
• A port range where the beginning and end port are separated by a dash, for example,
"5/8-13".
lines
Specifies the number of lines for the portLogDump output. This parameter is valid only with
the slot/port parameters.
Examples To display debugging information for a single port on a Brocade 5300:
switch:admin> supportshow 43
VF
======================
Date:
Sun Dec 6 05:10:13 PST 2009
Time Zone:
America/Los_Angeles
Version:
Kernel: 2.6.14.2