Reference Guide

Brocade Fabric OS Command Reference 1125
53-1004112-02
turboRamTest
turboRamTest
Performs a turbo SRAM test of ASIC chips.
Synopsis turboramtest
[--slot slot]
[-passcnt count]
Description Use this command to verify the chip SRAM located in the ASIC using the turbo-RAM BIST circuitry. The BIST
controller is able to perform the SRAM write and read operation at a much faster rate than the PCI operation.
Notes Do not abort this test prematurely, using CTRL-C or q to quit. Doing so may cause the test to report unexpected
errors. Errors may vary depending on the hardware platform.
You cannot interrupt the test by pressing the return key (<cr>).
The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric
OS Commands" and "Command Availability" for details.
This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable
command before you can run this test. After the test completes, re-enable the switch using the chassisEnable
command.
Operands This command has the following optional operands:
--slot slot
Specifies the slot number on which the diagnostic operates. All eligible blade ports in the
specified slot are tested. This operand is optional. The default value is 0 and operates on
fixed port count products.
-passcnt count
Specifies the number of times to perform this test. This operand is optional. The default
value is 1.
Examples To run the SRAM test with two passes:
switch:admin> turboramtest -passcnt 2
Platform bladeType 154
Running turboramtest ..............
WARNING:
This test should NOT be aborted in the middle. If aborted, current
blade or fixed configuration switch may become unusable.