Reference Guide

1170 Brocade Fabric OS Command Reference
53-1004112-02
zoneObjectReplace
zoneObjectReplace
Replaces zone members.
Synopsis zoneobjectreplace oldmember newmember
zoneobjectreplace --help
Description Use this command to replace the existing member of a zone or a Peer Zone with a new member. This command
can be used to replace members of an alias, but an alias itself cannot be replaced. This command is not applicable
for Traffic Isolation (TI) Zones, and Frame Redirect (RD) Zones.
The property member of a Peer Zone cannot be replaced using this command.
Target Driven Peer Zones are not allowed to be edited using this command.
For the change to become effective, enable the configuration with the cfgEnable command.
Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric
OS Commands" and "Command Availability" for details.
When an FCS policy is enabled, this command can be issued only from the primary FCS switch.
Operands The following operands are required:
oldmember
Specifies the the zone member that has to be replaced. You can specify WWN or
Domain,Index (D,I).
newmember
Specifies the new zone member with which to replace the old zone member. You can
specify WWN or D,I.
--help
Displays the command usage.
Examples To replace zone member:
switch:admin> zoneobjectreplace \
"20:00:00:05:1e:a1:af:b2" "10:00:00:05:1e:a1:10:c1"
switch:admin> cfgshow
Defined configuration:
cfg: cfg lsan_m
cfg: cfg1 zone2; zone3
zone: lsan_m 20:15:00:05:1e:a2:f9:b1; 20:13:00:05:1e:a2:f9:b1
zone: zone1 2,3; 20:00:00:05:1e:a1:af:b1; zali_1
zone: zone2 5,7; 2,9
zone: zone3 10:00:00:05:1e:a1:10:c1; 20:10:00:05:1e:a9:20:12