Reference Guide

ManualsBrandsDell ManualsAccess PlatformsBrocade G620

141

142

143

144

145

146

147

148

149

150

126 Brocade Fabric OS Command Reference

53-1004112-02

configDefault

Note that configDefault does not completely remove all FCIP tunnels and GbE IP address information. This may

be an issue when attempting to use the same information to create new tunnels or modify the existing ones.

The execution of this command is subject to Virtual Fabric restrictions may be in place. Refer to "Using Fabric OS

Commands" and "Command Availability" for details.

Operands This command has the following operands:

-fid FID

Specifies the Fabric ID of the logical switch for which to reset the configuration. This

operand is valid only in Virtual Fabric mode, and the executing account must have chassis

permissions.

-all

Restores all nonpersistent configuration parameters to factory default values (switch and

chassis parameters). This command requires chassis permissions.

-switch

Resets the switch configuration only. This operand is not valid in VF mode.

-force

Executes the command without confirmation and reboots the switch. This operand is

optional.

Examples To restore all system configuration parameters to default values:

switch:admin> configdefault -all

WARNING: This is a disruptive operation that requires a switch reboot.

Would you like to continue [Y/N]: y

Executing configdefault...Please wait

Already in Native Mode continuing with configDefault

Committing configuration ... done.

The switch has to be rebooted to allow the changes to take effect.

Switch rebooting .......

Restarting system.

The system is coming up, please wait...

To restore all system configuration parameters with -force option:

switch:admin> configdefault -all -force