Reference Guide

154 Brocade Fabric OS Command Reference
53-1004112-02
configure
Enable CLOSE on OPEN received?
If this is set, a CLS is returned immediately to an OPN if no buffers are available. This is
required for TachLite. The valid range is 0 to 4. The default value is 0.
Always send RSCN?
Following the completion of loop initialization, a remote state change notification (RSCN) is
issued when FL_Ports detect the presence of new devices or the absence of preexisting
devices. When set to 1, an RSCN is issued upon completion of loop initialization, regardless
of the presence or absence of new or preexisting devices. When set to 0, an RSCN is not
sent (default).
System Services Settings
The values for the System Services settings are as follows:
Disable RLS probing
Enables or disables the read link status (RLS) probing. Performed by the FCP daemon, RLS
probing reads the link error block from the device. This extended link services command is
defined by the FC standards. Refer to the FC standards for information. RLS probing is
enabled by default, meaning "Disable RLS probing" is "off". "on" disables RLS probing.
Portlog Events Enable/Disable Settings
These settings determine whether or not various types of port events are logged.
Each event type displayed on the screen is enabled by default ("on"). When disabled, this event is not logged by the
port log.
Application Attributes
A number of application attributes are configurable. The following table specifies the attributes for applications that
can be modified.
Application Field Type Default Range
_______________________________________________________________
ssl
Certificate File string [not-set] varies
CA Certificate File string [not-set] varies
Length of crypto key number [128] 40,56,128
rpcd
Secure RPCd Callback
Secret string none varies
Webtools
Basic User Enabled boolean no no/yes
Perform License
Checking and Warning boolean yes yes/no
Allow Fabric Event
Collection boolean yes yes/no
Login Session Timeout number 200 60 to
(in seconds) 432000
Notes The maximum per port login limit is no longer configurable with this command. Use the portcfgNPIVPort
--setloginlimit command to configure this parameter on a per port basis.
The Telnet interface is no longer configurable with this command. Use the ipFilter command to enable or disable
the Telnet interface.