Reference Guide

156 Brocade Fabric OS Command Reference
53-1004112-02
configure
Portlog events enable (yes, y, no, n): [no]
ssl attributes (yes, y, no, n): [no]
rpcd attributes (yes, y, no, n): [no]
webtools attributes (yes, y, no, n): [no]
switch:admin> switchenable
To enable Dynamic Area Mode on the default partition of the Brocade DCX:
switch:admin> switchdisable
switch:admin> configure
Configure...
Change fabric parameters? Y
Domain: (1..239) [160]
Enable 8 bit Dynamic Area Mode
(0 = No,
1 = Zero Based Area Assignment): (0..1) [0] 1
R_A_TOV: (4000..120000) [10000]
E_D_TOV: (1000..5000) [2000]
WAN_TOV: (0..30000) [0]
MAX_HOPS: (7..19) [7]
Data field size: (256..2112) [2112]
Sequence Level Switching: (0..1) [0]
Disable Device Probing: (0..1) [0]
Suppress Class F Traffic: (0..1) [0]
Per-frame Route Priority: (0..1) [0]
Long Distance Fabric: (0..1) [0]
BB credit: (1..27) [16]
Disable FID Check (yes, y, no, n): [no]
Insistent Domain ID Mode (yes, y, no, n): [no]
Disable Default PortName (yes, y, no, n): [no]
Edge Hold Time(Low(80ms), Medium(220ms), High(500ms),
UserDefined(80-500ms): (80..500) [500]
Remote Fosexec feature: (on, off): [on]
High Integrity Fabric Mode (yes, y, no, n): [no]
Virtual Channel parameters (yes, y, no, n): [no]
F-Port login parameters (yes, y, no, n): [no]
D-Port Parameters (yes, y, no, n): [no] yes
Dynamic D-Port (on, off): [on]
On Demand D-Port (on, off): [on]
RDP Polling Cycle(hours)[0 = Disable Polling]: (0..24) [1]
Zoning Operation parameters (yes, y, no, n): [no]
RSCN Transmission Mode (yes, y, no, n): [no]
Arbitrated Loop parameters (yes, y, no, n): [no]
System services (yes, y, no, n): [no]
Portlog events enable (yes, y, no, n): [no]
ssl attributes (yes, y, no, n): [no]
rpcd attributes (yes, y, no, n): [no]
webtools attributes (yes, y, no, n): [no]
SEE ALSO configDefault, configShow, configureChassis, ipAddrSet, portCfgLongDistance, switchDisable, switchEnable,
upTime