Reference Guide

Brocade Fabric OS Command Reference 171
53-1004112-02
defZone
When No Access default zone is activated, the following conditions apply:
• If the current effective zone configuration is disabled with the cfgDisable command,
the local switch converts this command to the equivalent of cfgEnable "d_efault_Cfg".
• If zoning receives a cfgDisable command from a remote switch that does not support
default zoning, zoning rejects the cfgDisable command in the second phase of RCS
because the remote switch does not convert the cfgDisable command to cfgEnable
"d_efault_Cfg".
--allaccess
Sets the default zone access mode to All Access, initiates a zoning transaction (if one is not
already in progress), and deletes the reserved zoning objects by performing the equivalent
to the following zoning commands:
• cfgDelete "d_efault_Cfg"
• zoneDelete "d_efault_Zone"
A cfgSave, cfgEnable, or cfgDisable command must be performed subsequent to the use
of this command to commit the changes and distribute them to the fabric. If a cfgSave is
performed and the fabric is already in the No Access default zone state, a cfgDisable is sent
to the fabric. For example:
• defzone --allaccess
• cfgsave
An audit log record is generated for each use of this command.
--show
Displays the current state of the default zone access mode.
Examples To create a default zone configuration:
primaryfcs:admin> cfgactvshow
Effective configuration:
No Effective configuration
primaryfcs:admin> defzone --noaccess
primaryfcs:admin> cfgsave
primaryfcs:admin> defzone --show
Default Zone Access Mode
committed - No Access
transaction - No Transaction
primaryfcs:admin> cfgactvshow
Effective configuration:
No Effective configuration: (No Access)
SEE ALSO None