Reference Guide

244 Brocade Fabric OS Command Reference

53-1004112-02

fcipLedTest

Exercises the GbE port LEDS on the Brocade 7840, FX8-24, and SX6 extension blade.

Synopsis fcipledtest [--slot slot | all]

Description Use this command to exercise the GbE port LEDs on the Brocade Brocade 7840, FX8-24, and SX6 extension

blade. The behavior of this command varies according to platform:

• On Brocade FX8-24, this test cycles through the port LEDs by lighting GREEN and then flashing GREEN on

all ports for 3 seconds. As the test continues the ports turn AMBER and then flashing AMBER for 3 seconds.

The LEDs turn off when the test has finished.

• On Brocade 7840, this test cycles all the port LEDs by lighting GREEN on all ports for 3 seconds. The switch

will reboot once the test is complete.

• On Brocade SX6, this test cycles all the port LEDs by lighting GREEN on all ports for 3 seconds. As the test

continues the ports turn AMBER for 3 seconds. The LEDs turn off when the test has finished. The blade will

reboot once the test is complete.

This diagnostic cannot be run on an operational switch. You must disable the switch using the chassisDisable

command before you can run this test. After the command completes, the ATTN LEDs flash amber, indicating that

the command has finished and exited. Enable the switch using the chassisEnable command to set the ATTN

LEDs back to black.

Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric

OS Commands" and "Command Availability" for details.

Operands This command has the following operands:

--slot slot

Tests all GbE ports in the specified slot. This operand is optional. This operand is valid only

on chassis-based platforms.

all

Tests all GbE ports in the chassis. This operand is optional. This operand is valid only on

chassis-based platforms.

Examples To test the LEDs on slot 4 of Brocade DCX 8510 with an FX8-24 blade.

switch:admin> fcipledtest --slot 4

PASSED.

SEE ALSO bladeDisable, bladeEnable, chassisDisable, chassisEnable, extnCfg, portLedTest