Reference Guide

274 Brocade Fabric OS Command Reference

53-1004112-02

fcrIclPathBWMonitor

Sets or displays FC Router ICL bandwidth monitor parameters for EX_Ports.

Synopsis fcriclpathbwmonitor --enable

fcriclpathbwmonitor --disable

fcriclpathbwmonitor --show

fcriclpathbwmonitor --help

Description Use this command to enable or disable the Inter Chassis Link (ICL) EX_Ports bandwidth Monitor feature on an FC

Router, or to display the current status of ICL bandwidth feature and the ICL slot bandwidth assigned to connected

edge fabrics. If no operands are specified, this command displays the usage. By default, this feature is disabled.

Notes The execution of this command is subject to Virtual Fabric restrictions that may be in place. Refer to "Using Fabric

OS Commands" and "Command Availability" for details.

Operands This command has the following operands:

--enable

Enables the ICL EX_Port bandwidth Monitor feature on an FC Router. In the enable mode,

FC Router will periodically check for bandwidth imbalances from each ICL slot of FC Router

to each ICL slot of neighbor switch connected through EX_Ports. A RASLog message will

be generated when bandwidth imbalance is detected or resolved to other fabric.

--disable

Disables the ICL EX_Port bandwidth Monitor feature on an FC Router.

--show

Displays the current ICL EX_Port bandwidth Monitor feature status and bandwidth from

each slot to connected edge fabric.

--help

Displays the command usage.

Examples To enable ICL EX_Port bandwidth Monitor:

fcr:admin> fcriclpathbwmonitor --enable

ICL bandwidth balance Monitor functionality is enabled

To disable ICL EX_Port bandwidth Monitor:

fcr:admin> fcriclpathbwmonitor --disable

ICL bandwidth balance Monitor functionality is disabled