Reference Guide

288 Brocade Fabric OS Command Reference
53-1004112-02
fcrProxyConfig
fcrProxyConfig
Displays or configures proxy devices presented by an FC Router.
Synopsis fcrproxyconfig
[-s importedFID devWWN slot]
[-r importedFID devWWN]
Description Use this command to display or set the persistent configuration of proxy devices presented by the local FC Router.
When used without operand, this command displays the persistent proxy device configuration; otherwise, it sets
the specified attributes to its new value.
The proxy device must be inactive prior to setting or clearing persistent attributes. Disabling EX_Ports (using the
portDisable command) attached to the relevant edge fabric, removing the device from the appropriate LSAN
zones, or disabling the physical device are valid methods of ensuring a proxy device is inactive.
Persistent proxy device configuration attributes apply to the local FC Router. Multiple FC Routers attached to the
same edge fabric coordinate to present the same proxy devices. As a result, persistent proxy device configurations
must be consistent across all FC Routers attached to the same edge fabric or unpredictable results may occur. If
the proxy device configuration is not altered, no action is required. If the configuration is altered, then care must be
taken to ensure consistency across all FC Routers attached to the same edge fabric.
When used without operands, this command displays the following information:
importedFID
The imported fabric ID of the proxy device.
devWWN
The port world wide name of the device.
Slot
The slot used for the device WWN. The device WWN-to-slot association is persistently
stored. The slot format is XXYYH, where XX specifies the translate domain area_ID (valid
values include F0H through FFH) and YY specifies the Port ID value or the low 8-bits of
the proxy device address (valid values include 01H through 7FH). The address of the proxy
device is derived from the PID format (for example, native, core, or extended edge) and the
proxy device slot.