Reference Guide

314 Brocade Fabric OS Command Reference
53-1004112-02
ficonCupSet
ASM
Active=saved mode
DCAM
Director clock alert mode
ACP
Alternate control prohibited
HCP
Host control prohibited
MIHPTO
Sets the missing interrupt handler primary timeout (MIHPTO) value for the CUP. The
following operand is required:
seconds
Specifies the timeout value in seconds. Provide a decimal value in the range between 15 and
600 seconds. The default timeout value is 180 seconds. If a value greater than 63 seconds
is specified, the timeout value is rounded down to the closest value divisible by 10. For
example, an MIHPTO timeout value of 86 defaults to 80.
CRP PID CHID
Sets the current reporting path (CRP). The reporting path is a CUP mechanism for sending
FRU-failure reports to a FICON logical path via FICON protocol. The logical path between
the PID and the CHID must exist and be in operational state for this command to succeed.
Use ficonCupShow with the LP option to display the logical paths on the switch. The
following operands are required:
PID
Specifies the Port identifier, which is a three-byte Fibre Channel Port Address.
CHID
Specifies the Channel ID (CHID). The CHID is the Logical Partition (LPAR) identifier
supplied as part of the FICON protocol header. The CHID is a 1-byte value in hexadecimal
format. The first nibble indicating the Channel Subsystem identifier (a value between 0 and
3) and the second the LPAR within that CSS (a value between 0 and F).
Examples To enable FMS mode for the switch:
switch:admin> ficoncupset fmsmode enable
fmsmode for the switch is now Enabled
To set the ASM bit in the mode register for the switch:
switch:admin> ficoncupset modereg ASM 1
Active=Saved Mode bit is set to 1
To set the MIHPTO value to 60 seconds:
switch:admin> ficoncupset MIHPTO 60
MIHPTO has been changed to 60 seconds
To set the current reporting path:
switch:admin> ficoncupset CRP 082300 1A